Specifically designed and engineered to reduce rotating mass for race vehicles. Suits all vehicles with a 60deg. seat angle and M14x1.5mm
These are not regular billet machined 6-point Ti nuts, but our own high-strength 100T forging of 6AL-4V Titanium with a 19mm 12-point head. Fully CNC machined after forging to ensure high accuracy threads and concentric seats.
Wheel nut material comparison:
Grade 5 Alloy Steel:
Yield Strength: 92,000psi
Ultimate Tensile Strength: 120,000psi
Shear Strength: 72,000psi
Density: .284 lb/in3
Yield Strength: 73,000psi
Ultimate Tensile Strength: 83,000psi
Shear Strength: 48,000psi
Density: .102 lb/in3
Grade 5 6AL-4V Titanium:
Yield Strength: 128,000psi
Ultimate Tensile Strength: 138,000psi
Shear Strength: 79,800psi
Density: .160 lb/in3
The minimum required wheel port is 27mm (outer diameter of these nuts is 24.8mm).
Use Permatex Anti-Seize on the threads and seat to prevent galling. This Anti-Seize typically requires a 30-40% reduction in torque, but it is important to test for your particular application using turns of the nut method.
Other important information:
These wheel nuts are for off-road use only and have undergone testing on track vehicles in racing conditions (including drift and circuit racing).
Do not use an impact wrench to tighten.
We cannot guarantee against galling due to incorrect lubrication during assembly, thread damage due to worn/damaged studs or damage due to over-torque or incorrect installation.
Wheel nuts are to be professionally inspected before and after each installation and discarded if any damage is observed.
WEAPON-X Motorsports 2017 - all rights reserved. ATS V, Cadillac, Camaro, Chevrolet, Chevy, Corvette, CTS V, Grand Sport, Stingray, ZR1, Z06, and Z51 are registered trademarks of General Motors Corporation. Weapon X Motorsports, Inc. has no affiliation with General Motors Corporation or its subsidiaries.